On when you arrive, off when you leave.
Get up in the night, or reach into a dark wardrobe, and it is already lit before your hand gets there. Stop moving and it switches itself off again about 20 seconds later. Nothing to fumble for in the dark.
Motion sensor cabinet light
No wires. No drilling. Just light.
Cupboards, wardrobes, stairs, store rooms. Lit the moment you reach in, dark again when you are done.
Motion Sensor Cabinet Light
₦14,950
- Senses you at
- 3m
- Switches off after
- 20s
- Runs up to
- 90d
Up in about a minute.
An adhesive magnet pad sticks to any flat surface and the bar snaps onto it. No screws, no drilling and no electrician. Lift it off to charge or move it somewhere else, then put it straight back.
Four modes, one button.
Short-press to cycle through On, Off, Day Auto and Night Auto. Night Auto stays off until the room has gone dim, so it ignores you in daylight and saves the charge for when you need it.
Months between charges.
On motion, the 1000mAh cell goes 10 to 90 days between charges, depending on the brightness you set and how often it is triggered. Leave it switched on as a lamp instead and it runs about 5 hours straight. Top it up over USB-C in about 3 hours, and the cable is in the box.
Five times the battery.
Most cheap sensor bars run a 200mAh cell. This one carries 1000mAh, so a single charge lasts up to 90 days. The body is aluminium rather than plastic, it has four modes instead of two, and the brightness actually adjusts.
Tech specs
- In the box
- One 40cm light bar, a USB-C cable and an adhesive magnetic strip
- Body
- Aluminium
- Light
- 32 LEDs at 6500K, dimmable by long-press
- Sensor
- Movement up to 3 metres across a 120° arc
- Switches off
- 20 seconds after movement stops
- Modes
- On, Off, Day Auto, Night Auto
- Battery
- 1000mAh rechargeable
- Per charge
- 10 to 90 days on motion, or about 5 hours left on as a lamp
- Charging
- USB-C, about 3 hours, no fast charging
- Mounting
- Adhesive magnetic strip, no drilling or wiring
Questions, answered
One 40cm light bar, one USB-C charging cable and the adhesive magnetic mounting strip. Add more than one to your order if you want to light several spots.
No. The bar runs on a built-in rechargeable battery and mounts with an adhesive magnetic strip, so there is no drilling, no wiring and no socket needed.
It picks up movement up to 3 metres away across a 120 degree arc, then switches off on its own after 20 seconds without movement.
Only if you want it to. Day Auto mode senses movement at any time, while Night Auto mode stays off until the room is dim, so it ignores daytime traffic.
Pull the bar off its magnetic mount, plug in the included USB-C cable for about 3 hours, then snap it back on. This product does not support fast charging.
Yes. Long-press the sensor button to adjust brightness, and short-press to switch between the four modes.